Home › Display settings › KT LCD3 / LCD5 / LCD8 (Kunteng controllers) › KT LCD3 / LCD8: trip reset

Resetting the trip counter on a KT LCD3 / LCD5 / LCD8

KT LCD3 / LCD5 / LCD8 (Kunteng controllers)

On the LCD3 the TRIP counter clears every time the display is switched off; there is no manual reset. The LCD8H adds a manual reset by holding buttons on the TRIP screen.

Step by step

  1. Press the power button briefly to cycle the data field: TRIP → ODO → time → voltage (order varies).
  2. LCD3 / LCD5: to zero TRIP, switch the display off and on. It always starts at 0.
  3. LCD8H: cycle to TRIP, then hold ▲ and power (some firmware: ▲ and ▼ for 3 seconds on the TRIP field) until it zeroes.
  4. ODO cannot be reset on any KT display without C10 (restore defaults), which also wipes your P/C settings.
Tip: If you want a trip that survives power-off (a day tour with lunch stop), use the ODO difference or a phone app; the LCD3 was never designed for it.

Can't find it?

TRIP does not clear on power-off: you have an LCD8 or an OEM firmware with persistent trip; look for the hold-to-reset gesture on the TRIP screen. TRIP clears while riding: the display is losing power for an instant (loose connector or C12 too high).

Frequently asked

Does Auto Off count as a power cycle?

Yes; the trip clears.

Can I keep TRIP but reset ODO?

No.

Where is average speed?

LCD3: none. LCD8H: cycle the field.

Other KT LCD3 / LCD5 / LCD8 (Kunteng controllers) guides

KT LCD3 / LCD8: switch km/h to mphKT LCD3 / LCD8: set the wheel diameterKT LCD3 / LCD8: assist levels and the P/C parametersKT LCD3 / LCD8: speed limitKT LCD3 / LCD8: password (C9)KT LCD3 / LCD8: backlight (C6)KT LCD3 / LCD8: walk assist and cruise (C7)KT LCD3 / LCD8: battery voltage and the battery barKT LCD3 / LCD8: throttle settings (P4, C4)
Still stuck? Take a photo of the display and show it to a local e-bike workshop. Bring the bike's system name (e.g. Bosch Performance Line CX) and the exact code; that saves diagnostic time and money.